Jump to content

Jets 1 And Circ Pump Will Not Run Simultaneously Causing Overheat Error


Recommended Posts

Please help. I have a spa crest hot tub. We have recently replaced the circ pump, and entire balboa box with circuit board and heating element etc. Circ pump is 24 hour continuous but kicks off when jets 1 is turned on causing dry and overheat error codes. The circ pump will continue to run simultaneously with jets 2. Im at the end of my troubleshooting skills. Any advice will be much appreciated!

Link to comment
Share on other sites

It's likely a dip switch or jumper that's not in the correct position for your configuration. A new control box supports many different configurations of equipment, circ pump/no circ pump, one speed pump, two speed pump, no pump 2, etc etc. There are almost always either electronic configurations that are programmable,physical jumpers, or dip switches, that must be in the correct position for the equipment in your spa.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...