smartypants Posted September 28, 2014 Report Share Posted September 28, 2014 I'm a new poster here, so apologies if this has been covered before. I couldn't find this specific question when I searched. I have a used, older 300 model softub (probably 3-4 years old). I am trying to set it on energy saver mode. I followed the directions on a downloaded owner's manual (hold down the "light" and ^ button) and it successfully flashes "24" on the digital display. I figure, I should be all set, right? But it continues to heat to temp all day. At first, I thought it was just filtering, but the "heat" light is definitely on, and it does it throughout the day, not just once as the manual says it will. Anyone have any advice? Our electricity bill is through the roof. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.