minivolks Posted June 9, 2013 Report Share Posted June 9, 2013 I have a jandy controller. The panel is in the house. The controller box is outside next to the filter. From that it is connected to a pool pilot dig 220. Question. Why isnt the display board on the pool pilot working? I can't even run the pump for the pool. I am assuming no power to the pool pilot. From the jandy controller in service mode I can here the relay click, but nothing. I can run the pump for the water falls. I think the pump for water falls is in same relay as pump for pool. Do I need a new pool pilot? Can I check to see if approprite power from jandy is going to pool pilot? I am handy with a volt meter. I do not see anything burnt inside the pool pitol. I can also turn on lights in pool. Also, I can remotly turn valve for solar heat in service mode. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.