Jump to content

Pump, Blower, And Heater Will Not Start (Coincidence?)


chriskthx
 Share

Recommended Posts

I have three problems that all happened together concerning my spa equipment.

1) The blower will not start. I suspect it is an electrical problem, as when I turn the switch absolutely nothing happens. I have reset the breaker in the panel board and checked the wiring inside the blower. What seemed odd is that the switch only had a red wire hooked up to it (as well as the green ground). The black was not connected to anything. See picture below. Did something happen internally?

2) My spa pump is will not start. For the past two days, it had been working but at an extremely loud noise, which I suspected was the bearing. Just today, it fails to turn on and only makes a humming noise. After 10 seconds, the humming noise stops (no breaker was tripped). See link to video below.

3) My heater will not turn on. Is this because the pump is not turned on, and no water is flowing through it? Or are they completely independent?

I have ensured that power is getting to the panel board next to my equipment, as my pool light works (same panel) as well as another outlet. My equipment is 8 years old.

Pump: 2 HP Hayward Bay North Star

Blower: Silencer 1HP

http://www.youtube.com/watch?v=KMDEf-qnx0A

7mvmv.jpg

Ad6pE.jpg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share



×
×
  • Create New...