mdwheaton Posted April 24, 2012 Report Share Posted April 24, 2012 My symptoms are I have ONLY the power light, no other lights light. My thermistor was cracked and there were burn marks on the board. I replaced the thermistor, no change. Even when I disconnect the RJ11 for the flow switch, there is still no change, not even the "No Flow" light lights. I checked the voltage into the rectifiers, all good. I checked the output voltage from the rectifiers, all good. I checked the resistance on the transformer, all good. The display shows 2600 always...instant salinity reading is 0.00. The two thermistors on either side of the power input "look" ok... What to check next? Quote Link to comment Share on other sites More sharing options...
Pool Clown Posted April 24, 2012 Report Share Posted April 24, 2012 how old is the cell? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.