hurook Posted June 7, 2011 Report Share Posted June 7, 2011 I have an issue with a Z115/Z315 echo spa. I had it up and running all last year just fine until winter came. Then when I went out to check it one week, the spa had shut down and there was a thin layer of ice on top, about 1/4" or so. The breaker had tripped. I tried restarting to see if I could "save" it rather than unfreezing and draining. The pump motor kicked in for a few seconds and then quit. So I used space heaters to completely thaw and then drain the spa. This spring, I have no power power to the topside control. I did isolate the pump motor to make sure I didn't burn it out and it works. There is power to the board as I was using a multimeter to check a few of the relays. I haven't replaced the fuses yet, but will do so just to rule it out. Just looking for suggestions as to where I should start troubleshooting from someone with more experience. Any help or suggestions is much appreciated! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.