SquashPro Posted December 18, 2010 Report Share Posted December 18, 2010 My pool needs re-plastering as the the existing plaster is etched and discolored after 18 years. I talked to a pool re-plasterer today and asked him if it was OK to replaster a pool during this time of year or if I should wait until spring. He said that he re-plasters pools year round and that they simply drill some holes in the bottom of the pool to make sure that there aren't any problems with the pool floating when they drain the pool during the winter. He claims that there is no problem with doing the re-plaster this time of year. BTW, I'm near Sacramento and the temperatures right now are averaging about 50 degree highs and 40 degree lows. It's raining which is keeping nighttime lows from dropping lower. I asked if the low temperatures this time of year affect the curing of the new plaster. He said that it was OK to re-plaster so long as the outside temperature was above 40 degrees and that the big issue with plaster curing occurred if it became too hot. I don't have any big reason why the re-plaster couldn't wait until the springtime. However, my guess is that this time of year things are slow for the pool guys and I might be able to get a better price if I re-plastered now rather than delay to the spring. I'm wondering if the pool guy is just telling me that it is OK to proceed now because he is anxious to do the work or if it is really OK to do the work now. Can anyone shed light on this situation? Is it important to wait until the air temperature is warmer and when the ground is drier? Quote Link to comment Share on other sites More sharing options...
Pool Clown Posted December 18, 2010 Report Share Posted December 18, 2010 I don't have any big reason why the re-plaster couldn't wait until the springtime. However, my guess is that this time of year things are slow for the pool guys and I might be able to get a better price if I re-plastered now rather than delay to the spring. I'm wondering if the pool guy is just telling me that it is OK to proceed now because he is anxious to do the work or if it is really OK to do the work now. Can anyone shed light on this situation? Is it important to wait until the air temperature is warmer and when the ground is drier? I don't know about the Sac area, but I know for us, you will get better attention to detail in the off season as we have more time to spend on your job to finish things off. If you have no rush, i would wait till it dries out and warms up a bit, but don't wait so long that it gets busy (mid to late spring). However with the economy, it may not get as busy. Are you using Jeremiah Pools? Quote Link to comment Share on other sites More sharing options...
quantumchromodynamics Posted December 18, 2010 Report Share Posted December 18, 2010 I think that as long as the minimum temperature is above 40 degrees F for 4 days before plastering, the day of plastering, and until the pool is full, then temperature shouldn't be a problem. During periods of daily rain, the local water table can get higher than normal, which can increase the risk of floating, or water weeping through the gunite while plastering. However, the water table can be controlled to prevent the possibility of the pool floating and to prevent the possibility of water weeping into the area between the plaster and the underlying concrete. You don't want to plaster on a windy or rainy day. Here are a few references you can review if you want further, more detailed information. The last reference link might not work, is primarily for commercial pools, and is really too much information, so you should probably skip that one. Reference 1 Reference 2 Reference 3 Reference 4 Reference 5 Quote Link to comment Share on other sites More sharing options...
SquashPro Posted December 18, 2010 Author Report Share Posted December 18, 2010 Thanks to both of you for the great replies! Quantumchromodynamics, the references were great. BTW, I have not talked with Jeremiah Pools. Quote Link to comment Share on other sites More sharing options...
Pool Clown Posted December 18, 2010 Report Share Posted December 18, 2010 BTW, I have not talked with Jeremiah Pools. Just wondering, used to know some good people that worked there. Quote Link to comment Share on other sites More sharing options...
waterbear Posted December 18, 2010 Report Share Posted December 18, 2010 Here are a few references you can review if you want further, more detailed information. The last reference link might not work, is primarily for commercial pools, and is really too much information, so you should probably skip that one. Reference 1 Reference 2 Reference 3 Reference 4 Reference 5 Then why did you post it? KISS! Quote Link to comment Share on other sites More sharing options...
quantumchromodynamics Posted December 19, 2010 Report Share Posted December 19, 2010 Then why did you post it? KISS! I answered the OP's question. I also provided additional information because there are people who want that type of information. Here are a few references you can review if you want further, more detailed information. Quote Link to comment Share on other sites More sharing options...
Philip Posted July 17, 2023 Report Share Posted July 17, 2023 The average temperature in my area, Rancho Mirage, CA, is around 90 degrees Fahrenheit in August when the pool resurfacer wants to do the work. I have found sources that state that above 75 degrees the plaster will dry too fast and cracks may occur. Should I postpone having the work done until the temperatures are lower? Quote Link to comment Share on other sites More sharing options...
waterbear Posted July 17, 2023 Report Share Posted July 17, 2023 @Philip, you posted in a 13 year old thead. You stand a much better chance of getting an answer if you start a new thead and ask your questoin. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.