Jump to content
Sign in to follow this  
romac

Spa Side Remote Problems

Recommended Posts

I have an in-ground spa adjacent to my pool. The spa has a Pentair 4 button remote wired to the main controller (Compool). The Spa Blower recently seized and, perhaps coincidently, the remote stopped working. I have replaced the blower and have full control of all spa functions from the indoor control panel and service panel in the control box. While the remote properly flashes when the spa heater is on, the controls do not work. I subsequently connected a replacement remote and found that it did not work either. My guess is that there is a problem in the controller circuit board, or there is a disable remote feature that I am not aware of. Any ideas before I call for pool service

Thnx,

Romac

Share this post


Link to post
Share on other sites
I have an in-ground spa adjacent to my pool. The spa has a Pentair 4 button remote wired to the main controller (Compool). The Spa Blower recently seized and, perhaps coincidently, the remote stopped working. I have replaced the blower and have full control of all spa functions from the indoor control panel and service panel in the control box. While the remote properly flashes when the spa heater is on, the controls do not work. I subsequently connected a replacement remote and found that it did not work either. My guess is that there is a problem in the controller circuit board, or there is a disable remote feature that I am not aware of. Any ideas before I call for pool service

Thnx,

Romac

On some of the compool controls there is a switch in the control box marked outdoor remotes and has a on/off sliding switch.

If yours has a digital type buttons in the control box I am not sure but should have something. ALso is the control box in AUTO not Service

Share this post


Link to post
Share on other sites

I have similar problem as Romac. In my case the spa side remote comes on when the pentair control box is in auto and my Compool CP3600 pool spa control system activates the spa side remote. Problem is that only 1 of the 4 buttons respond (the one for the air blower). The other 3 are dead. Any guess what might be the problem? Vents, cleaner, heater, lights, and everything else work fine both from the pentair control box as well as the Compool. 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...