Jump to content

Search the Community

Showing results for tags 'softub 220'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Hot Tubs & Spas
    • Portable Hot Tubs & Spas
    • Inflatable Hot Tubs
  • Inground, Fiberglass and Aboveground Swimming Pools
    • All Swimming Pools Types
  • Swim Spas & Exercise Pools
    • Swim Spas & Exercise Pools
  • Pool/Spa Water Care
  • Swim Spas & Exercise Pools
  • Pool/Spa Water Care
    • Hot Tub Water Chemistry
    • Swimming Pool Water Chemistry

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests


Location


Interests

Found 3 results

  1. Hello, I am wondering if someone could help with this, I recently got a softtub for free which sat around for a couple of years. I first cleaned it and filled it, ran the jets and a lot of this black/green film came flying out of the jets. I’m assuming this is some kind of thing that happens when you leave water sitting in the lines for a while. I did this to clean out the system since I knew this sat around not being used. I drained the soft tub and cleaned everything out with a garden hose and made sure that nothing would be floating around when i turned it on again. so here is my issue, the soft tub will turn on when I plug it in but gives me a P code, the jets will kick on but there is no temperature display on the console, it runs for a minute or two then the temperature comes back on, the tub reached the temperature i needed it to be at and then completely shut off again. I reset the tub and turned it back on again, now it runs for a minute with a P code and then shuts the whole thing off again. I’ve looked into this and the most common response I have is you need to flush the temperature housing. How do I do this? And if I do this or have to replace the thermostat will this fix the issue?
  2. Hi all. I’ve been reading the boards for about a month now with my new softub 220. We use it about 1-3 times a week. My dealer has a very hands off approach to water chemistry. (Add a cap of dichlor after every use, keep ph in range, everything else will sort itself out). After reading the boards, you could understand I’m suspect of the dealers advice. Softub warranty prevents any shocking and they do not recommend using any MPS as the low ph causes issues with the tub liner. We’re on the first fill still, started with dichlor and transitioned to using the frog@ease. Ph has required moderate effort to keep in range by adding here and decreasing there, but TA has been very difficult to keep up. It drops to 0 in 2 days. Stabilizer has been at zero since day 1, but the dealer said don’t worry about it. Is this normal? All the boards I’ve read talk about HOW to increase/decrease TA, but I’m not seeing anything saying how OFTEN people are adjusting for TA. If my TA is so volatile, I’m sure that’s affecting my PH. At this point I can’t imagine not testing daily because things get out of hand every other day. How do you all set up your ph/TA so you can only check weekly?
  3. Plugged in. Heat indicator on. No jets. 15 secs or so pops breaker. Keep trying other outlets. Breakers popping. Is it only a mattet if a dedicated breaker or should i be concerned about motor? I have no way to test without installing new breaker and outlet.
×
×
  • Create New...