Search the Community
Showing results for tags 'precision jet'.
Found 1 result
-
My education in spa plumbing continues! Thanks to the help I received on this board I have spliced in a new stretch of flex pvc to fix an earlier leak, replaced my jet pump’s wet end, but now . . . I found another leak. This one is right at the base of where a piece of flex pvc enters a 4-way junction (“manifold”?). Based on the location (rear right of the spa) and the number of pipes I assume this feeds the four precision jets located just above the moto massager. Unfortunately I do not think there is any un-broken flex pvc near the base onto which I could cement a fitting. So what do you think? -I could plast-aid around the leak and hope for the best; - I could cut out the whole assembly and splice in a new 4-way manifold snug up against the larger t fitting below, and then splice in 4 pieces of flex pvc with a fitting each; or - something else? If #2, I assume I just buy a new fitting like this? Here's a video of the leak. It's hard to see but i think the break is on the lower right most pipe, facing in toward the other pipes. Apologies for the shakiness. And thanks in advance for any help! https://www.youtube.com/watch?v=yrCf-5eaExw