Search the Community
Showing results for tags '2 speed pump'.
-
"Jets 1" is a 2 speed pump and it used to go into high speed when pressed and then back low speed when you press it again, but now it is acting as if it is only a one speed jet and a very low one at that. Not sure what happened. Any advice?
- 1 reply
-
- 2 speed pump
- south seas spas
-
(and 1 more)
Tagged with:
-
Ok, So my wife decided we needed to get this used hot tub from her friend, long story short, I poured a slab and moved this thing to my backyard. Wired, and found/fixed leaks. Replaced 1 bad pump. (waterway executive 56 5hp Both are 2 speed.) Ok, so no Idea of the manufacturer, Cover around the filters says "Phoenix Spas" Control says Balboa The Spa Pack is a VS501z by Balboa. The heater is an M7 style SO... hopefully these are most of the details needed. I'm a plumber so I understand pumps and what not. Issue #1 The pump connected to the heater, is that supposed to be the Circ or the Pump 1? I would think it should be the Circ to move the water around thru the heater, but I'm not an expert. The new pump I installed was originally plugged in the Circ port on the board. However this pump wont run of the control panel. I know the spa heater works, tested and had the spa up to temp at 1 point of time. Now its acting goofy. I have no history on this tub, but know I can fix about anything with a little direction. Any suggestions or ideas? Jeff
-
- 2 speed pump
- balboa
-
(and 1 more)
Tagged with: