Search the Community
Showing results for tags 'cameo'.
-
I am having trouble identifying the source of air bubbles in my spa. All air valves are off, and there are no bubbles when the pump #1 diverter is in either position, nor are there bubbles when pump#2 diverter is in the B position. The air valves all work as they should. However, when I move #2 diverter to the A position, bubbles mix in with the flow out of the footwell jets (where are should not be coming out at any time) I have replaced both diverter valves, and there does not seem to be a leak anywhere. Any thoughts on where I should look for a source of air intrusion into the flow for this one diverter position? Thanks! Jim
-
I have a 2002 Sundance Cameo 850 and am trying to program/configure it for optimal energy use, and to NOT run the heater during peak electricity periods which would be between 7am and 7pm. Buy configuring my circ pump cycle to start at 7pm and run for a duration of 12hours (shutting off at 7am) and then turning on economy mode, I was hoping that this would prevent the heater from coming on during the day even when the tub falls below the set temp, but allow it to come on during the circ pump cycle of 7pm - 7am, when the tub calls for heat. It appears though that in encomy mode, the heat will only come on during a programmed filter cycle -- see experpt below from the manual: "In economy mode, the low speed pump #1 and heater turn on only during a programmed filter cycle or when either JETS sensor is pressed" I also have the 4 filter cycles setup such that none are running during the PEAK 7am-7pm period. This tub pre-dates some of the more modern controller capabilties, so I am limitted to what can be done. To best accomplish what I am trying to do, I am thinking of programming a filter cycle to run say for 2 hours starting around 7pm. While in Economy mode, the heat should run during this period and replenish the little bit of heat lost during the day when the heater does not come on. Any thoughts/experience on this??
-
I am looking into buying a Sundance Cameo and something that is bugging / interesting me is when you compare the impact the Sundance Ecowrap has across their 880 range the Cameo stands out as not getting the same level of efficiency improvements. Does anybody know why this is specifically the case with the Cameo?
- 3 replies
-
- Sundance Cameo
- ecowrap
-
(and 1 more)
Tagged with:
-
Hello all, My 97' sundance cameo 850 won't let me change the set temp when powered on. It's stuck at the factory 80deg F The up and down arrows work on the pad, the two temp probes show a very similar reading for the correct number of ohms. The screen won't lock, but does let you change the time using thoes keys. Any ideas? Thanks!