Jump to content

Search the Community

Showing results for tags 'Clearwater'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Hot Tubs & Spas
    • Portable Hot Tubs & Spas
    • Inflatable Hot Tubs
  • Inground, Fiberglass and Aboveground Swimming Pools
    • All Swimming Pools Types
  • Swim Spas & Exercise Pools
    • Swim Spas & Exercise Pools
  • Pool/Spa Water Care
  • Swim Spas & Exercise Pools
  • Pool/Spa Water Care
    • Hot Tub Water Chemistry
    • Swimming Pool Water Chemistry

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests


Location


Interests

Found 1 result

  1. Hi everyone. So we finally caved and bought a new to us Clearwater, circa 1997. I don't know the exact model, I can't find it anywhere and like a meathead, I've lost the paperwork. It has Balboa controls on it. Long story short I got it all wired and filled and fired it up, and everything seemed fine besides a pretty substantial leak next to the niche. Water temperature was 62.7*F (ambient 65.5*F) out of the hose. After a few hours had gone by, it had climbed to 67.2*F. Awesome. I did some reading on biofilm, grossed myself out so ran to the nearest store to grab some cleaner. Was gone about an hour and a half total. I came home to the spa controls displaying "Oh." Water temperature was 67.7*F. Pump was not running. I decided to cycle the power at the breaker and when I did that, I was immediately greeted with an "Sn" code. Pump does not operate at all, doesn't go through priming, just goes straight into "Sn." Have cycled a few times, this is all I get. What paperwork I've fou​nd shows that typically a machine will operate with an Sn code, and it should flash with another number. Is this correct? I pulled resistance readings and showed 61.6kohms on the temp lead, and 54.4kohms on the high-limit (which if I understand properly is the one that goes to the shell, near the footwell. I do not have dip switches to enter a test/diagnostic mode. This was with the water temp at 63.3*F. If it matters, part numbers are as follows: Control Module: Balboa DU-GRDELT-DCA 51597 Top side controls: Balboa/Clearwater, two numbers 51558 and 33394 Sensor Assy: Balboa 30337 Edit: More information - tub has not been used for at least a year, probably much longer. Tub was stored dry, clean and covered.
×
×
  • Create New...