Jump to content

DelawareBlueHenHottub

Members
  • Posts

    4
  • Joined

  • Last visited

Everything posted by DelawareBlueHenHottub

  1. As for the check valve, I do not see a check valve like this:https://backyardplus.com/category/plumbing/check-valves/ in the cabinet. There is this fitting leading into the circ pump inlet. (All tubing clamps have been correctly place and are not leaking)
  2. I did the sensors as one of the earlier attempt to correct this Protection Mode issue, but the Protection Mode returned within 24-36 hours of replacement. Filters are out, water is full. Haven't replaced the circ pump yet as I can see the water circulation in the filter box and coming up from the bottom of the hot tub. I will upload photos this evening of the circuit board.
  3. Thanks for your assistance. I installed the sensors in January. I will unplug the ACE System this evening and update. Anything particular about the check valve that I can look for? It is weird to me that I can get the blue light to remain solid for 12-24 hours and then will start flashing. Thanks again!
  4. I have a 2013 Hot Springs Prodigy with 230V that has provided solid service until recently. Protection Mode issues presented and I have taken following steps: 1) replaced filters (PM remained) 2) replaced thermistors (PM remained) 3) replaced heater (PM initially went away then 24 hours later returned) 4) researched issue and read that sometimes led light sometimes causes PM issues so I disconnected led plug (PM went away for 24 hours and returned). Did observe good circulation flow and 230 on multi meter. Any suggestions for what I could do next to resolve this very frustrating situation! Thanks in advance
×
×
  • Create New...