Jump to content

ChuckP

Members
  • Posts

    6
  • Joined

  • Last visited

ChuckP's Achievements

Newbie

Newbie (1/5)

1

Reputation

  1. Ok got new pressure switch in and it heated up. All good there. Now it seems like the circ pump constantly runs and i see an F1 on the display. Display looks broken up but its at 103 deg F, the camera did this. You can clearly see the f1 tho.. I did have to replace the knob that controls the waterfall, it had cracked during winter. Just the knob and the guts. Also put a new filter in.
  2. Ok shut off breaker, disconnected the heater wires from board. assume its the 2 black cables that go into the silver pipe that are connected by nuts. I got 15.4 ohms across them and no continuity to case. Based on the above video linked I ordered a pressure switch, will be here Friday. Hoping thats the problem, will report back when done. Thanks
  3. This hot tub has been running like it its setup for 10 years now, no jumpers/wires have been messed with. This problem arose 2 days ago. I am getting 120v on each heater leg but yet the board shows there is no heater on per the leds in the below picture
  4. Filled the hot tub last week for the daughter and he friend. She noted after being in it for a while it wasn't as hot. Really wasn't that cold of a night. Noticed it running yesterday and saw this on the display. After cycling the jets its stopped running but saw the temp was at 95 deg even tho set to 100 deg I shut off tub at breaker last night to reset but eventually came back on. Long story short, hot tub runs constantly, keeps tub hot but not up to right temp and has 2 sets of dashed lines on the display. I see alot of mentions of a pressure switch, could that be my problem? Thanks for the help...
×
×
  • Create New...