SkunkApe

Just got the replacement board delivered today. I just finished swapping it out and that was the culprit. Everything powered on and now working normally with the new board Thanks for the help everyone!

Haha go figure! I’ll update as soon as I swap it out.

No spikes that I can recall. I have a new board ordered and should be here Monday. I’ll probably pull the old one out sometime this weekend to have a look. Thanks!

It’s about 3 years old. was installed back in 2019 from what I could gather. We moved into this house about a year and a half ago. Has been running fine up until late last week.

Thanks! yeah, I put a new fuse in yesterday, disconnected the topside/touch screen, flipped the breaker bad on and the fuse blew immediately. I was anticipating I need a new board, but just wanted to cover all bases.

Hi all, hoping someone can lead me in the right direction. My Hot Tub has no power. I first verified that I'm getting the correct 240v going to the Hot Tub, so I decided to dig a bit deeper. The GFCI is NOT tripping, however there is a blown 2A 250V fuse. (I attached the board diagram and outlined the fuse that keeps blowing) At first, I switched the GFCI off, replaced the fuse, flipped it back on, and I can see the fuse blowing immediately. Flipped breaker off again, I unplugged every component I could see going into the board (pump, heater, topside, etc,etc.) replaced the fuse again, flipped breaker on with everything unplugged, and the fuse still blew. At this point, I'm not sure what else it could be. Could it be a bad board? Could it be something else? Anybody have any suggestions? Thanks!