Mike 133

Hey, everyone! Softub’s service and parts are one buttoned up operation! It takes dozens of hours online to make heads or tails for any kind of diagnosis or location of parts. I have an 06’ 300 and wondering if anyone else has experienced their motor getting up to operating temperature, then suddenly tripping itself. It won’t allow itself to reset until the motor fully cools. To help rule out possible contributors: It’s plugged directly into a dedicated circuit, runs smoothly with no bearing noise, shaft spins freely, strong water flow in stainless steel tube, entire pack is dry and now free of leaks after replacing a cracked split nut. My best guess is a thermal trip or some kind of short in the motor? I have a new motor ordered, just because I’m desperate and decided to start throwing money at it, but My question is there any other component outside of the motor (I’m not thinking of) that would cause the inline GFCI to trip after 20-30 minutes of run time? Any thoughts or experience would be greatly appreciated. Thanks! -Mike K.