Jump to content

Daniel wagg

Members
  • Posts

    4
  • Joined

  • Last visited

Daniel wagg's Achievements

Newbie

Newbie (1/5)

0

Reputation

  1. Thanks for you’re comments . Yes I’ve tried bleeding from all joints just incase . I’ve now had the circulation pump and heater running for 16 hours or so but doesn’t seem to be heating up. Not getting the fault code at that moment but I’m sure it will be back . where do I find the flow sensor ?
  2. Hi anybody ? I have a Chinese style hot tub . I have a fault code of “cldf” basically , the tub has stopped heating up to desired temp. I have installed new filter incase this was the cause I’ve even tried to run without filter . I have checked all obvious places for air locks after I re filled water . I did this correctly through filter chamber . my sparky has removed cover and when he gives the relays a tap this does start things in motion but not for long . It then goes back to cldf error Code and a beeping . currently it’s left turned on and it does a 10 second circulation or so then a bit of heater running then back to cldf . this is a random time every time .
  3. I have this exact problem . I have just replaced both wet ends on both pumps . re filled tub through filter housing. turned on and get cldf and a beeping sound. I have checked for air locks on all three pumps and removed filter still getting this cldf code and heater isn’t staying on . Any ideas anyone ?
×
×
  • Create New...