Smith87

But other than the light situation I couldn’t be happier with the new pack. Thanks for the info and link on last topic.

Orange is old harness new harness is just white and black

I bought a new balboa vs series spa pack to replace my old balboa 52326. The vs runs a 2 wire 2 pin led light. What I would like to do is to be able to use my existing 3 wire led lights as well. Is this remotely possible

Story of my life haha

My meter has 20k ohms still noth ing

No just unplugged the heat sensor/ on the heater tube & Tub housing as well as the pressure switch none of the three show any resistance

The high limit relay and heater relay

Shouldn’t I have 240 between the heater and hi limit when running a heat call

I’m not sure it was on it when I got it. It just sucks because if I buy relays and it doesn’t work, I buy heater with no change then i buy board. If it goes that way I’d been better to buy whole unit and heater lol. They’re not hot tubs their land boats😂

Both green ground and neutral. Showing 240 volts on heater.with the heat turned off I’m reading 32-34 on terminal 1 and 3. Unplugged the sensor harness everything shuts off with code sn1. And the picture isn’t clear bc I have my labels on my wires still. Also for the wiring diagram front cover was gone off unit when I got it. That’s also the clearest picture I can get of breaker with my iPhone 5 lol

Also on my terminals 1-6 all are reading around 125v except for number 1 it’s reading 30-40 which is where my other heater wires is. With the heater wires unhooked k3 high limit relay is engaged

Well got board back in and now it’s flashing oh or throwing breaker 🤯

Got ya thanks

Yes, voltage is steady. No noise. little black box is for ozone generator. if equipped. Relays seem to be ok As well

Sorry fluctuating voltage powered on with heater wires disconnected

No, on the board itself with wires disconnected the ohms fluctuate. S

It was indeed infinity

My mistake I meant infinity

I checked the continuity I didn’t happen to look at the reading at the time. I am wanting to think 1

Have a used leisure bay spa g2 balboa pack with a dry element. Finally got it working properly. Has been for about 3 months. Now my heater is tripping the breaker. Unhooked heater it no longer trips. Checked the resistance and it is 15.5 ohms on element. Unhooked heater lines from the board, ohms are fluctuating all over the place. Any help would be greatly appreciated.