Indiekid
-
Posts
6 -
Joined
-
Last visited
Posts posted by Indiekid
-
-
On 6/4/2021 at 1:44 AM, tjr said:
I am in the USA so your spa is wired a little different could you show the inside of IQ box cover that has wiring and jumper configurations. ON USA Spas If the lim ok is not lit up the power light(red) on control panel will be flashing.
On 6/4/2021 at 1:44 AM, tjr said:I have attached the image showing the jumper config
-
4 hours ago, RDspaguy said:
Ok. On the board is a big yellow square. To the right of that a bit is a stack of 3 leds labeled htr on, control unplugged, and lim ok. Are any of these lit when power is on? These leds are tiny but bright, you can't miss them if they are on.
These are tiny LEDs but they are not illuminated when powered up. Not sure if that’s good or bad 🤦🏻♂️
-
-
-
Hi,
Any help would be very much appreciated, drained down and cleaned the filters ready for refill. Refilled and powered up and added Chemicals and run clean mode. Several hours later the blue light started blinking on the control panel. None of the control buttons work. Drained again and refilled but still no buttons work.
Any ideas on how to resolve ?
I know the tub is a little old now but it is in mint condition.The other blue lights around the tub also blink blue.
Hotspring sovereign 2008 blinking blue lights
in Portable Hot Tubs & Spas
Posted
I have attached the image showing the jumper config