Jump to content

Indiekid

Members
  • Posts

    6
  • Joined

  • Last visited

Everything posted by Indiekid

  1. I have attached the image showing the jumper config
  2. These are tiny LEDs but they are not illuminated when powered up. Not sure if that’s good or bad 🤦🏻‍♂️
  3. Actually when the connector is pulled from the board it looks fine no scorching on the board. I can’t see the led is labelled up with anything but it did have a new board a few years ago. Thanks again for your help much appreciated 👍🏻
  4. Hi, please see attached short video. The green led is flashing but I have noticed some markings on a connector on the left hand side of the pcb. Lost my current tester so will grab another tomorrow 🤦🏻‍♂️Is it worth cutting the connector off and banging a new one on? IMG_7345.MOV
  5. Hi, Any help would be very much appreciated, drained down and cleaned the filters ready for refill. Refilled and powered up and added Chemicals and run clean mode. Several hours later the blue light started blinking on the control panel. None of the control buttons work. Drained again and refilled but still no buttons work. Any ideas on how to resolve ? I know the tub is a little old now but it is in mint condition. The other blue lights around the tub also blink blue.
×
×
  • Create New...