I think I ran our SPA too low on water and did some damage. The display of the top side control has been broken for years, we've been able to use the spa with no visual feedback. I noticed the SPA was low and mean to top off with water. Was running all day and when I came out the next morning tub was cold 78 F vs the normal 104 F.
I've cleaned and replace the filter twice. Reset a few times to no avail. Held at 78 F for past few days. Today I investigated the heating element and it's registered 12 Ohm on the MultiMeter so I assume the element is still good and that is not the issue . Following the wire back to the control panel it's damaged (fried). Not sure if this is new or old damage but as a precaution I removed the harness.
My concern now is best approach to get the SPA back up and running, we are in Montana so nights are cold, I'm worried about freeze damage and wondering if it would be best to try and keep the tub warm or just do a through job draining the next warm day.
AcuraSpas has priced a replacement SpaPack, Heater, and topside for $600 which seems like the way to go. I'm tempted to try and find a replacement harness and seem how much longer I can get the tub to hobble along. It's a 10 years old and not sure how many more seasons we will get out of it.
Mountain Spas Tub
Azure Plus Control Panel i200
Any help, suggestions on repairs, or leads on where to find wiring harness would be a greatly appreciate.
Thank you!