Larry W Canepa

Thank you for all your help I replaced the main board, and it is all working fine. Once I got the board out of there, I found smaller burn spot on the board its real small and was hard to see but now that I know where it is it is easy to see if you look at the picture of the board very top and center once more thank you CanadianSpaTech you were patient and helpful. Larry (San Diego CA) enjoying our hot tub again.

thank you for al the help it dose look like the main board i will order today and update after installed

I had check the transfomer 12 vots I did that in the begging but will do all the rest when I get home and the transfomer runs the lights also so I figure the transfomer is fine I will get back afte I check the rest and thank you so much for your help

I did disconnected the top panel ribbon wire from the main board and turn power on nothing form the motor, this is a one pump spa. The wire in the picture is a temp wire for power wile diagnosing we are redoing its location and yes it had stopped working before we moved it. Note I have the heater disconnected due to this is a 30amp wire for testing only.

It is where one of the plastic clips on the ohter side comes through to lock in the board why its brown dont know maybe a sealant

i took the board off and nothing stood out as burnt larry

nothing runs. i's like there is no power to the spa and fuses and good. I do have 220/240 to the spa but the two buttons on the pad for the lights inside the spa function just fine. fyi i am an a contractor with a strong back ground in electrical so i do know for sure it is hooked up properly. thanks for your help.

Good Morning and thank you for your reply sorry I did not explain properly Year 05/14/14 what is going on is the spa dose not turn on and or no display light up with the exception of the lighting system is working fine it like the power is turned off to the spa except this lighting system. The photo is with the power on and the two lower left lighting buttons function and lighting control Larry

Ok I have a Jacuzzi J325 my top side control pad has display thought the LED color changing lights are working from the top side control pad just tiring to decide weather to switch the topside panel or the mother board it had tripped the GIF a couple time in the passed. not much more its been a good spa. would like to know if there are any further test i can do to zero in on the bad part. Thank you for any help Larry