Hi there,
My two speed Wavemaster 6000 does not seem to run on low speed. It just hums for about 10 seconds then shuts off. However, it will run on high speed. My display is also not displaying properly so I am not sure of the error codes that I might be receiving. I have a 2012 Hot Spot SX. Any way to figure out if it is the motor or a control panel not reading/registering properly? Is there a starter capacitor for the low speed and a run capacitor for the high speed? And what is this high-temp reset switch that I keep running across in comments? Also, my "ready" light keeps flashing on control panel. . AAAAArrrrrrgggggg