Hello! I installed a Pentair IntelliConnect controller today.
I wired up the main pump (Intelliflo) and SWCG (IntelliChlor) via RS-485 cable + dedicated power supplies, as well as a booster pump to the first relay.
Everything peachy so far.
Next up, I was going to wire a MasterTemp HD400 to the "Heater" relay on the controller.
I followed these instructions: (Page 30)
Basically, I cut the fireman's switch jumper cable, and "extended" it into the controller's Heater relay, so that it would close the circuit.
As far as I can tell, that's the right way to do it, but the controller wouldn't turn on the heater. I restored the jumper cable, and now the heater does not turn on at all. (There is power going to it, which leads me to believe I somehow fried the logic board).
Is this the right way to set up the controller? Did I miss anything obvious? (Any help would be appreciated so that I don't end up killing another board once I replace it)