Kube1989

I powered it up in both conditions. The flow is there regardless even with the low flow message. The message on the screen only says low-flow for about 15 seconds then it kicks into saying heating to 102 degrees. Whether the filters are in or out it starts off saying low flow for the first 15 seconds. And the circulation pump is throwing a steady stream of water coming out of the two ports.- within 1 or 2 seconds of powering up the tub. I have not pulled the flow switch connector and jump them I'm kind of in the middle of prepping dinner 🙂

And as for the flow switch... I just did a full drain and clean and rinsed then cleaned then rinsed again all the filters. Soon as it turns on I can see the flow from the circulation pump right away but it comes up first saying low flow. This is a brand-new circulation pump that has the integrated flow switch.

Buy locked out I mean if I just turn on and off a light or turn jet to on the low or low or high or back off it acts fine as soon as I turn on jet one which of course goes into low position first after that none of the controls on the control panel work until the timer has run out for the Jets

Sorry been awful busy and haven't had a chance to get back around two things. Attached is the controls and the top side. I thought maybe it was a problem with the pump itself but when I switch comp input on the spot pack it still has the same effect Jets 1 locks out the controls until the timer runs through

It is a 2004 diplomat ultralife. Been working fine all of a sudden today even though circulation pump is moving water great when powered up it said low-flow. If I turn on pump two it lets me go to low and high speed and turn them off but once I turn on pump 1 it come comes on in low and it won't let me turn it to high and none of the other controls other than the light bulb work at that point. Any ideas?

Tub is used- says manufacture date is 6-4 (is that June of 2004 or April of 2006?) Night before last circ pump got really noisy for about 30 sec and then popped breaker. Breaker would not reset unless I unplugged circ from spa pack. I put in a new circ pump yesterday and all was well. Tub is at 102 and holds water. Overnight I got the Low Flow. Filters are new, mesh screen is clean and new black plastic inserts in filter wells. This was first night of actual use- was sitting empty for 9 mos. Can the filters need rinsing ALREADY?!? I just don't want to burn the circ pump up. Please advise. Thanks!