Dear,
After filling the spa with too hot water (not smart, I know now…), I’ve got a blinking red and green light on the display panel of our Hotspring spa, a model somewhere roughly from between 2002 and 2005.
I understood that the hot water may have tripped the high limit switch, as also mentioned in the user manual, or even worse but less probable, broken one of the components.
I’ve been looking to reset this switch in the first place, but cannot find how. I cannot detect a switch on the heater nor on the board. So I haven’t got a clue how to solve the problem. The configuration consists of:
- no fault Watkins heater, type without reset button
- control box IQ 2020
Ozon and pumps not affected. I’ve got the bubbles and can use the jet sprays.
As the problem may result from a tripped switch, would short wiring on the board of this switch be an ultimate option ?
Any advice, comments, suggestions would be deeply appreciated.
Many thanks in advance,
Dirk