Hey guys, I used information from this forum to diagnose and attempt a repair on my HotSprings Landmark spa.
The tub quit getting up to temp and I discovered that the heater relay board was blown out. From info I got on this forum I took it off and checked the back and sure 'nuff, smoke and burning on the back of the board.
The jets and circ pump and everything we're still working on the tub when I took the old board off, the only problem was the water not getting up to temp.
Well I turned the breakers off and waited a few days for the new board to show up.
I installed the new board tonight and flipped the breakers back on and all I'm getting is a flashing red light.
The temp display comes on with 8888 and all of the little icons for a second and then goes blank. No pumps are coming on, no sounds. Just a flashing red light.
The little LED lights for HEATER ON, and LIM ON (I think that's what it says) are no longer on. When the heater board went out, those were still on. Now they're not on at all.
I tried to bleed the air out of the lines, thinking it was airlock, but that doesn't seem to have done anything either.
Any suggestions?
I'm in need of some hot tub jets on my confused body!!
Thanks guys!