coreyva

Thanks! After speaking with James, he pointed out that it was my remote panel causing the sporadic running of the motor. Which in turn, caused the water to heat up. 5 minutes later, the panel is disconnected and all is well. This guy knows what he is talking about. Definitely contact him if you have issues with yours. He saved me several hundred dollars by not investing in the wrong part. Thanks again James.

No thoughts? Am I correct with starting with the logic board?

I have a 2004 Cameo 850 that started acting up. First I noticed that it went to 106 several times, but never past. I shut the spa down for some time so that the temp would lower. When powering the spa back on it would be fine for a few days and then return to 106. Then pump two started cycling erratically. Even when the temperature was below the preset (103) it would come on for 10-15 seconds then turn off and repeat this behavior. Since the schematic is essentially worthless for the logic of this control board, I'm trying to determine what would cause this behavior. I'm thinking it's probably the control board, but before dropping the change for a new one I want to make sure I'm not missing anything else. Any ideas?