Jump to content

JNC

Members
  • Posts

    2
  • Joined

  • Last visited

JNC's Achievements

Newbie

Newbie (1/5)

0

Reputation

  1. I have a Jandy 250 LoNox natural gas heater. The unit is about 11 years old. The heater won't reach the temp set on the RS6 control. It seems to start cycling on and off at about 95 degrees. Topping off about 98 - 99. The spa is set at 101. It will work properly once in a while. I have repaced the temp sensor, and flame sensor. The blower motor was going out. I thought that may have been the issue also. After I replaced it the unit heated the spa right up to temperature. Then the same issue started again. I'm out of ideas on what the issue is. Anyone experience this? Thoughts on what the cause may be?
  2. I have a Jandy LX 250, about 8 years old. It is connected throught the fireman's switch to a Jandy RS6 control center. Both thermostats (pool & Spa) on the heater are set to max. The heater will come on and bring the water up to the temperature set on the control center. When the water temperature drops, the control center activates, however the heater doesn't come one. I hear the blower fan for maybe a minute. then nothing. No error lights, and the spa or heater light remain solid. Rather than start blinking when the burns are light. I hear no ignition clicks. It seems after it sits for a while, the heater will come on, and the process will start all over again. I have replaced the temperature sensor, and cleaned the flame sensor. Any thought on what the problem may be? Thanks,
×
×
  • Create New...