northstar

Anybody have the Jandy Power Center PCB #8124A trouble shooting document? I have the 25 VAC to the PCB and the 3 Amp fuse is good on the PCB. Thanks much.

It is a two stage both 110 & 220. When I test the pins coming out of the board (white and black) it is 220 Volts but when I test the wires going into the motor is shows 110 volts. Can you describe how to test the safety switches?

It is a Jandy LX 2006. I imagine I would put in a Jandy LXI?

For somebody who is pretty handy and use to fixing most everying around the home, is installing a new pool heater doable or something left to the professionals?

My Jandy LX 2006 model heater's blower will not start. I verified that that there is power (110 V) across the top two wires (black & white) on where this plugs into the board. The blower moter spins freely. I assumed this meant the blower motor was bad and purchased a new one. Without installing the new blower (just plugging it into the board), the new blower also does not start. Need your help. Thank you.