seegek

Hi Pool Clown, You replied to post 51 but what about 50? Thanks, Seegek Hi Pool Clown (or Sly, El Neno or Las Vegas Lizard), Looks like you have been a big help to others. I am receiving error codes 172 & 186 and went through the service troubleshooting guide. For the 4-5 backboard am recieving 0 mVDC vs 120 and on K_H .12 vs 120. With sensor disconnected with temp/salinity/ up or down buttons both give HH whereas it should be 91. With the sensor connected though it gives HH for down and 91 for up, whereas the Troubleshooting Front Board page say it should be 91 for down. The 172/186 flow chart page does not specify whether the sensor should be connected or not, so with sensor connected, and up arrow, I got 91 so answered no to HH or 32. Although I am logical, these instructions seem to indicate both the front panel and flow sensor are bad, for example gives right 91 reading for up with sensor connected, but front board troubleshooting says sensor disconnected and down arrow. Found best internet sensor price at $144 plus $13 ground shipping on discountpoolmart.com and front board for $300 elsewhere that does not seem a commonly available, so I want to make sure before buying the wrong one. Thanks a million. I am willing to send you a $20 service fee, if we get it right. Also flow sensor three SS disks are clean,but there is a fourth grey one that was slightly covered by plastic, so I removed plastic. This did not help, but not sure if it damaged sensor, if it was not already bad. Help.

I believe you too have a sensor failure. That seems to be happening to me alot too out in the field.