Jump to content

cstultz

Members
  • Posts

    53
  • Joined

  • Last visited

cstultz's Achievements

Spa Savant

Spa Savant (3/5)

0

Reputation

  1. My 12 year old artesian will drain completely out even without being turned on. I cant find the leak anywhere. I have no clue. I have it sitting so 2 sides are hard to access. Im sure i need to call someone in to check.
  2. I have a pump that I need to replace on my artesian spa. It's a bigfoot 6hp pump. This is the model #pubfs602582f. Anyone know where to get this for cheap?
  3. I did. I ended up running the neutral wire and putting in a ground.
  4. Just bumping this, looking for an answer.
  5. I have a bad jet! Water is coming through the air control. How do I know which jet needs replaced?
  6. I have a artesian spa. Its about 10 years old. I just bought it 2nd hand. There are about 20 jets that are missing the outer covers. They're lying around in the tub. I just can't figure out how to get them to stay on. Also, I have a bad jet somewhere. When I turn the air control valve to on, it leaks a steady stream. Any suggestions on how to find which jet is bad?
  7. I had a similar issue with mine. It was the connection at the lowest intake. I had to turn it on its side and cut it out to replace. PAIN IN THE BUTT!!! Especially, working on it by yourself. Im having a leak now at the air control. I'm sure its a jet. Just not sure which one.
  8. Have a white grayish slime in some of my lines and along the filters. I'm assuming this is dead algae? Any ideas on getting rid and removing this?
  9. So I got this used spa. Its an artesian piper glen model. One of the pumps (#2). Is not turning on. Im assuming its probably just a bad pump. I have another pump from an old thermospa. Think I can just swap them? I haven'treally taken it apart to look at the compatibility yet.
  10. Just bought a used Artesian Spa on Craigslist. I moved it, sat it place, cleaned it, filled it with water, and hooked it up to the power source I had on my old thermospa. NOTHING!!!! I checked for power coming in. I only have 3 wires. A ground and 120 on the other 2. According to the manual, it should still turn on without the neutral line going in??? Am I missing something silly? Should there be any lights on the control board or something like that? There is absolutely nothing! I did notice a few fuses. I'm going to check them later. Where can I get a detailed schematic?
  11. Didn't work. I spent 10 hours in the hot sun on the hottest day of the year. The tub had rotten boards and the insulation was full of water. It was HEAVY!!! I'm going to Starr calling towing/moving companies
  12. I'm doing this tomorrow. I'm pretty much doing it alone. I'm getting a 6x12 utility trailer from uhaul. Im a friend of mine try to help. She is pretty little. I figure I can lift it enough to get it on the pvc. Then follow a track I'm going to make across the lawn. I'm hoping to use 2x8's as a ramp, pull it up with a come aling and then tie the heck of it when I get it on the rails. I'm driving about 80 miles. I have to map out a route where I can take backroads. Will it work?????
  13. Wow. I have called almost every equipment rental place in NH. None rent snowmobile trailers or any trailers bigger than 5'x8'. You'd think with NH being a big snowmobile area that you could find them everywhere. Most people have theirs in enclosed trailers. I do have a friend with one. It holds 2 snowmobiles. Hopefully, it fits the measurements. Did you push it on to the trailer? Use a come along? A winch? I'm going to be moving this by myself.
×
×
  • Create New...