Leaderboard

Yes, Hot Spring makes a kit, part # 76230 which is a circulation pump kit for the SX and TX.

You should be able to adjust the temp sensors though the menu. Be careful not to over calibrate them. And be sure you are getting an accurate temp reading from where the freeze sensor is. Not necessarily what your weather app says it is, or even the thermometer out on your porch. Freeze damage usually costs more than running the equipment to prevent it. Another note The freeze protection routine in the Aqua-Link (I think) will come on at 34 to 36 BUT wont turn off until it reaches 38. with no adjustment.

Perhaps the mender nut got put on backwards or in the wrong place? With the hose disconnected from the barbed end(wall fitting), put the mender nut on the wall fitting with the shoulder of the nut facing away from the barb, or towards the wall of the pool. Install the hose all the way to the shoulder of the barb fitting, about 1 1/2". then just thread the mender nut onto the hose. It should tighten down and become difficult to tighten any more. If you can continue to tighten more than say an inch and a half, then the hose will no longer hold the barb and you'll have to replace the hose. If the hose is misshaped on the end, you can try cutting the misshapen portion off, 1 to 2 inches, and try again.

The peanut gallery is open under new management.😂