JIMBO48

TRIED THE POWER-DOWN AND UNPLUG ROUTINE--DID NOT HELP. UNIT HAS NOW BEEN POWERED DOWN FOR ABOUT 4 WEEKS SO I AM SURE IT HAS HAD ENOUGH TIME TO "RESTART" BY NOW. I CAN ORDER NEW MOTHERBOARD FOR HOT TUB--SMAE NUMBERS AS ORIGINAL--WILL THIS TAKE CARE OF THE PROBLEMOF CHANGING HIGH SPEED PUMP TO LOW SPEED AND CONTROL ALL OTHER FUNCTIONS--CAN GET REPLACEMENT BOARD FOR ABOUT $275.00--WHAT DO YOU THINK?

THANKS JOHN FOR REPLYING--WAS HOPING I COULD GET IT WORKING WITHOUT HAVING TO REPLACE ENTIRE CIRCUIT BOARD (EXPENSIVE!!) --MAYBE EVEN THE CHIP BUT CANNOT SEEM TO FIND CHIP ANYWHERE ON LINE. JIMBO48

ABOUT 7 YEARS OLD AND HAD BEEN WORKING GREAT UNTIL THIS.

LIGHT WAS NOT WORKING SO I SHUT OFF HOT TUB TO CHECK LIGHT BULB AND CONNECTIONS--WHEN I RESTORED POWER THE HOT WOULD NOT COME ON, ONLY "CLICK". I PUSHED THE RESET BUTTON ON MOTOR AND PUMP CAME ON AFTER RESTORING POWER, BUT PUMP RAN ON HIGH AND I COULD NOT CHANGE OR STOP IT--NO LED READOUT ON TOP-SIDE CONTROL BOX--REPLACED TOP-SIDE CONTROL BOX (APPEARED TO HAVE MOISTURE IN BOX) AND RESTORED POWER BUT NOTING HAS CHANGED--PUMP STILL RUNS ON HIGH AND NO LED READOUT ON CONTROL BOX. ANY SUGGESTIONS: MOTHERBOARD, CHIP/EPURN OR WHAT?