robbsclassics

Ok, so got it hooked up and started to get it working. It seemed to be ok, but then overheated and there was no circulation. Before I could get to the breaker it tripped. After that I get an sn1 code. So I need to clear it, and replace it. How would I clear the code? I would like to at least see if I can bypass it to get some circulation to at least see if everything works. Thanks in advance.

Ok, so got it hooked up and started to get it working. It seemed to be ok, but then overheated and there was no circulation. Before I could get to the breaker it tripped. After that I get an sn1 code. So I need to clear it, and replace it. How would I clear the code? I would like to at least see if I can bypass it to get some circulation to at least see if everything works. Thanks in advance.

I have a 1989 Seven Seas hot tub. It's an LX-30 with 2 dual speed pumps. The circuit board was sent out to be tested and fixed and I have gotten it back. The problem now is that I don't have the pics I took of how all the wiring gets reattached. D'oh. Most of the connections are labeled, but not the main power and heater. I need to know what way the 6 240V connections get wired in on the bottom of board. I would greatly appreciate if someone could give a diagram, or even go out to their hot tub and snap a pic so I could see how the wires go.