Jump to content

Recommended Posts

Posted

Jandy LXi250N (240V supply) ignition fault.

Sequence:

-manually open gas supply
-turn on heater to pool (water temp 68 set temp 74)
-blower turns on
-after 15 secs the ignighter lights up (visually checked)
-I hear a click about the 1 min mark
-another click at 2 mins
-another click at 3 mins
-no flame ignites during this time
-red led flashes 3 times repeatedly and the ignitor dims
-blower goes through 1min purge cycle then shuts down
-"Check ignition control" is displayed on screen

-haven't noticed the smell of gas yet

Electrical tests performed:
(from reading pages 41-50 of the http://www.poolcenter.com/images/jandy_heaters_LXI_manual.pdf

'>Jandy LXi manual)

-107V between GND and F1
-107V between GND and ACH1
-transforer voltages D-E 125V, D-F 202V, E-F 105V
-both water pressure wires 25V to GND
-all 4 limit sensor switch wires 25V to GND
-resistance of igniter 69 ohms

All of the above are in range I beleive from reading the LXi manual.

What do I check next?

One thing to mention is that my temp sensor is faulty. So I replaced it with a 20K ohm pot while we wait for the new sensor to arrive. It seems to have worked becuase the screen now sees the water temp at 68 deg. I don't see this as related to the issue but just in case I mentioned it.

Any help with what to do next would be appreciated.

Posted

My guess is a stuck gas valve. The solenoid is clicking, but the valve is not opening.

Good call. Guess I figured the clicking was the gas valve opening but a solenoid makes perfect sense. Not smelling gas should have been the first clue.

Hate to admit it but I was pretty ignorant on this one. I didn't know the gas valve had an ON/OFF switch as well. The guys who closed the pool down in the fall must have turned it OFF. I turned it to the ON position and she fired right up.

Well at least I have learned a tonne about this heater in 2 days. Thanks for pointing me at the right part.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...