presbull Posted June 12, 2010 Report Posted June 12, 2010 Don't know if I'm in the right place since this is my first post. My 2 port cell Jandy Aqua Pure generator had a 125 code. Cleaned until shiny bright (about 20 minutes in 1 to 3 acid solution). Replaced and now getting a 120 code. In checking the three prong connector, there was corrosion on one of the pins and inside the socket. Cleaned both and still getting the 120 code. How do I troubleshoot from here. Cannot get the troubleshooting manual mentioned in earlier post on this topic (page not found error). Any suggestions will be appreciated. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.