Jump to content

Jeffbg

Members
  • Posts

    4
  • Joined

  • Last visited

Jeffbg's Achievements

Newbie

Newbie (1/5)

0

Reputation

  1. My TA is pretty high by normal standards and I've only heard one way to reduce it and it seems unappealing. How do people typically reduce the TA in their pools? -- Jeff
  2. We have an Intellitouch i7 controller attached. It seems that it controls the pool well enough, though I suppose that the heater and the controller temp sensor could be out of alignment with each other. Any other suggestions? -- jeff
  3. I'm a new pool owner with all pentair equipment. I notice that when I turn on the spa (manual heat mode), then it comes on and runs the spa. Once it reaches the target temp, the heater shuts off. Now, as it cools, the heater does not come back on when I would expect it to. I called Pentair and they said that the temp has to drop by 3-4 degrees before it comes back on. We've observed that it overheats the spa a few degrees before shutting off the heater in the first place too. Is this something configurable or some sort of problem? It seems that the temperature reading at any given time is about right. The pool with solar seems to heat up and shut off the solar at about the right times. Thanks for any advice! - Jeff
  4. I'm a new pool owner and trying to read up on test kits. One thing I've not seen is a salt level test to cross-check my chlorine generator's own readings. Are these typically part of the test kits? Not required? Done via strips? Thanks in advance! -- jeff
×
×
  • Create New...