Around November I had a series of events on my Saratoga spa that is causing me a major problem now
First the Circulator pump went bad causing the heater to go bad and while replacing both water got on control board and blew that out. Anyway while waiting for these parts to arrive the temp got down to 0 and stayed that
way till end of February. I had drained the tub but Not as thoroughly as I guessed. When I started it back up
the other day after filling it and getting it to temp I turned on the pumps and lost every bit of water in about 20 seconds. So I figured I had a major leak somewhere Found about where the leak is and started digging into the rigid insulation. Using a wire wheel I managed to get to a "T" that burst but to repair the fitting I need to remove a bunch of insulation just to get to where I can remove the piping.
So after rambling here does anyone know of a better method for removing this rigid sprayed in insulation