Hi everyone!! I am new here and thought I would see if someone can help me with my problem.
I have a Sta-Rite SR400LP heater that wont fire. The blower starts up, runs, I hear the gas valve click and smell gas but no fire. No codes just service light comes on after three tries and the ignition board flashes lock out.
I checked the igniter and it works (pulled out and watched it glow).
I also had spare parts so I tried the following:
gas valve - no luck
ignition control - no luck
Stacked flue switch - no luck
It had a problem prior that it would cycle the heat and I replaced the thermostat/spring assembly.
It has a new thermister from last year.
I checked the wiring and it looked good - none chewed up.
I checked the air tubes and blew threw them to make sure no debris.
The air flow switch does close the contacts when I put a meter on it.
Could it be the control board under the membrane?
Any help would be greatly appreciated.
Thanks