Jump to content

n5eea

Members
  • Posts

    4
  • Joined

  • Last visited

n5eea's Achievements

Newbie

Newbie (1/5)

0

Reputation

  1. I got out a flashlight and looked everywhere I could see inside the motor compartment. I did not see any label with a number starting with a G-. At the top center inside the compartment is a black box where the electrical connections occur. There was a label on that box that stated Model G/K. Also, I did as you recommended previously and took the screws out of the diverter valves and reseated them. In a couple cases, it made a difference. I found I had little teeth broken off 2 handles, teeth appeared to be off one valve (under the handle). And I had one handle (on top, left of the front control) that was different than the rest and that handle was cracked. Can I PM you some images and what I think are part numbers for the diverter handles and valves? May from that, you can determine the correct model for replacement parts? Thanks, Rog
  2. Where do I find the serial number? I looked inside the pump area and only found a model number G/K on a label where the power connects. Thanks.
  3. Thanks for the reply. Is there such a think as a parts diagram for this that I could look at to see if its the same? Mine doesn't have a cap over the screws. Looks more like a waterproof sticky label. I did take one off earlier today. I can't say it changed much. But I'll look at them again on Saturday. Do you think this just needs an "adjustment" or does something need to be replaced? Also, I noticed some times when I turn the jets on (not always), air seems to "surge" out from a couple jets. Air seems to always come out the jets when the controls are ON, but the air flow increases and decreases. What would cause this? New parts needed for this??
  4. I have about a 10-12 year old Hot Springs Grandee spa, I got it as a used unit (no manuals). I'm not sure the actual name for the parts, since I can't find a parts manual for it. My local Hot Spring dealer does not have any parts manual for this model, but he's eager to charge me to come out and look at it. I looked at Hot Spring web site and could not find anything about replacement parts support. On the top of the spa, there are 1 or 2 air diverter controls on each size. I have a couple of these that when I turn the control clock-wise or counter-clock wise, there is no change in the water, whether it passes water or not or whether the flow is faster or slower. I think the part is something I can replace, but I'm not sure of the parts I need to get. If I can identify them, I might be able to find replacement parts for it. Also, I have a few missing boards for the side of this I wouldn't mind replacing. Any idea where I can locate these? Thanks in advance. Rog
×
×
  • Create New...