thirrsty1 Posted December 12, 2014 Report Share Posted December 12, 2014 Hi I'm new to the forum and hot tubs. My hot tub has been working good since iit was given to me a year ago. My current issue is a top control panel with a bad LCD (picking up a new one later today) and it's currently not heating. I do not have 220V across the heater electrodes. I am missing the phase on the right hand side (HTR1) not sure where to go from here. Any help is greatly appreciated. Thanks Quote Link to comment Share on other sites More sharing options...
thirrsty1 Posted December 13, 2014 Author Report Share Posted December 13, 2014 Ok I got the new topside controller in and during the startup it read Pr. After the priming was done the LCD displayed SLP. Now I can't get it out of sleep mode. My manual says to press the mode button but that is not working. I tried other combinations of button pressing but no luck. Can anyone give me some input? Thanks Quote Link to comment Share on other sites More sharing options...
PreservedSwine Posted December 15, 2014 Report Share Posted December 15, 2014 You're just in sleep mode. Try hitting the temp button before hitting mode, and see if you can get it back into standard. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.