pete1956

I had a fiberglass pool installed this summer, When i had the concrete work done around the pool I tool the guy that i wanted to put a diving board in, I went to work and he did the cement work, When i came home i told him about the diving board and he told me that i should have had reed bar installed for the suport , The work is all done, he is cleaning up , I know they put wire mess in the cement, Can i still put a board in. the cement is around 4 inches thich, will it hold or bust up the cement,

The pool was pulled out and sitting on the ground, They are doing the whole thing over again, I know that they are doing the best they can do to get the job done rite,

No pictures were taken, I was at work at the time, How do they reset it, Does this mean all the water has to come out and the pool has to come out of the ground, If they were looking for a 1/4" they must have not been looking at all

Had a new fiberglass pool installed, The tile border around the pool is not even all the way around the pool at the water line, the deep end seem to be sitting lower that the shallow end, One side of the deep end seem to be tilting to the side more then the other, We had heavy rain the other day and the pool filled all the up the water was over flowing on the deep side were it was tilted, the shallow end had at least 1 5/8" before it would over flow, the deep end on the side not tilted had about 1" before over flow, The pool has no concrete around it, The installer told me it would level it self as it sits, Is this true any help, Does the pool have to be reset ?

I been dealing with water world, They don`t clean up after them selfs, Leaving me with the mess, nothing but problems, I hope everthing gets straight this spring, They like to do things the way they like not the way you want, Costing me more money, They will tell you anything you want to hear untill they get your money, Then they can careless, I know i have been rip off