summerschad

when i manually restart the pump i have to push the Pump1 button twice to activate the pump at full/high speed. the light comes on when i push it once for low speed but it doesnt turn on, it may hum a little bit (i would have to check again to make sure). i have not let it just sit to see if it activates on low for an extended period. when i hit it twice it turns on high speed and works. i then hit the button again and it reverts to low speed and runs fine until reheat. the pump then turns off as it is up to temp. once the temp goes down the heat light comes on and the pump does not pump and it overheats. thanks for the reply. if this pinpoints anything futher please let me know. id hate to buy a new pump when its a board problem or vice versa.

Overheating getting OHH error. I have a proform spa with 2 pumps, the first pump having 2 speeds. My tub heats up to desired temp and then shuts off as it is supposed to. When the heater turns back on, the pump (pump 1, low) does not start/circulate water causing an overheat. Short term solution has been to push the button to reactivate the pump and then it heats back up again. This works until the tub heats back up again, shuts off, heater turns back on and another OHH... Daily problem and sometimes the system locks me out and doesnt let the pump turn back on for a while. It is not an airlock, I have removed the pump on a couple occasions. Wondering if this is a pump problem or circuit board problem. Pump works fine when running but just doesnt turn on when the heater does. Any help or advice would be appreciated.