SpaMattG Posted December 30, 2014 Report Share Posted December 30, 2014 I have a 98/99 Hot spot RLX, it has been working pretty good so far, I have it hard wired for the 30amp 110v setting. My question is my temp guage setting is off by about 5 degrees. I set the temp on the control panel to 104F, but according to my 2 thermometers its really only about 99-100 on a good day. OnceI go past 104 on the controller it says U1 U2 U3, my guess is those are upper level settings, but I dont really know what those stand for to be honest. I was just wondering if there is anything I can do to calibrate the sensors, so my temp is slightly more on target. Thanks in advance Matt Quote Link to comment Share on other sites More sharing options...
PreservedSwine Posted December 31, 2014 Report Share Posted December 31, 2014 You are correct, ut1, ut2, ut3 are settings over 105, 106, and 107. The nomenclature was a workaround specific verbage in UL requirement at the time, that the temp, ".. cannot be set higher than a temp displaying over 104." Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.