stilloriginal Posted October 13, 2012 Report Share Posted October 13, 2012 We had a problem with staining from metals....Pool expert said it was from the copper in the heater (we recently rennovated pool and the builder installed a salt system and a new heater). Pool expert said I let the pH get too high and there was too much chlorine which caused the staining. He repaired all damage. However, after he was done I couldn't get the pool filter clean enough to keep the pressure down. So finally I caved and bought a new filter. Everything has been going fine for the last month, until a week ago, during normal monthly maintenance, I added a half bottle of stain control (sequesterant). This week the pressue shot way up, the motor started whining... I just took the filter out to clean it. The water washes out blue.... I did get it sparkling clean (just using water). The pressure did not drop, however.... IS the blue-ness from metals in the water (like how copper corrodes blue-ish)? Am I having a problem here? Since the problem was corrected I have kept the chemicals very nicely. The pH shot up before I did the chemicals last week, but it couldn't have been up more than a few days as I have been doing the chemicals weekly or even more often. I tested the water 3 days ago and everything was on target. Thanks for any advice..... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.