KevinJK

The tub works normally for days\weeks. It never trips when not in use (cycles through heating and filter normally). Sometimes it will trip after my wife and I get into the tub and we turn pump 1 on high speed, but not always. Once it has tripped, I get out and reset the breaker. It will last about 3 seconds, then trip again. At this point no pumps or heater are turned on. I have even disconnected the pumps and heater and breaker still trips. It just keeps tripping 3 seconds after reset. Eventually everyone gets out of the tub and then I reset breaker. Tub now works fine with heater on and all pumps running at high speed. Is the pressure switch causing the breaker to trip? I ask this as it only happens when we are in the tub which is increasing the pressure on the switch. Any ideas?

I had to change pump 1 fuss from 25 to 30 amp.

I think I figured this one out on my own. I connected the neutral from the spa to the common neutral in the spa buddy box instead of the neutral in the GFCI. I will fix tomorrow and reply back.

Hi, The GFCI is tripping right away when I turn on the breaker. I do hear a click coming from the control box when I flip the breaker ON. I have disconnected both pumps, the ozone and the heater but still get the same result. I have checked the GFCI breaker by disconnecting all load, flip the breaker ON, and the breaker stays on. Any ideas? Thanks, Kevin