Jump to content

k.walkr

Members
  • Posts

    3
  • Joined

  • Last visited

k.walkr's Achievements

Newbie

Newbie (1/5)

0

Reputation

  1. OK...I think I understand and thanks for the advice and for not making me feel stupid (which I probably should). I plan on following the procedure from now on and not pay a lot of attention to the "pool dude". Thanks again.
  2. I don't think there is a way to lower or raise without affecting each other....But this reading here is sure to work. I have done it plenty of Times.. It's not a overnight fix, but it will work Can't seem to get that link to work
  3. I am new to the forum and hope you folks can help. I have 16K gunnite pool. I can't seem to balance the water. Here is the problem. No matter how hard I try, I can't seem to balance the PH without increasing the TA. For example, I had a PH of 7.0, When I added enough Borax to raise the PH to 7.5, it also raises the TA to about 180. Another example. I had a yellow mustard problem and the pool dude recommended a chemical called "Yellow Out". This product is most effective at a PH of 8.0 so he calculated the amount of soda ash to add to my pool so to bring the PH to 8.0. When I added that amount, my PH rose from 7.1 to 7.5, but my TA went off the charts at 250. Today, I added muriatic acid to lower the TA and it is now at 150, but my PH dropped to 7.0 Now the question....from what I read, Borax was supposed to ONLY raise your PH...not your TA. I thought by adding muriatic acid in one spot in the deep in of the pool, it would ONLY lower my TA...not my PH. Is there any way I can lower or raise one of the other without it effecting the other.....
×
×
  • Create New...