Jump to content

fady

Members
  • Posts

    3
  • Joined

  • Last visited

fady's Achievements

Newbie

Newbie (1/5)

0

Reputation

  1. Thank you Pool Clown, I located the sensor , it was hiddin facing downward on pvc pipe, I took it out and cleaned the three small silver sensor buds and plugged it back, recycled power but nothing change , still reads "SALT 25500 PPM General Fault, check aquapure " message. does this mean sensor is gone or there is something else that could be checked?
  2. Hello quantumchromodynamics Thanks for your reply but I'm having a hard time locating the Flow/Temp/Salinity Sensor , my system is APURE700 , the assemply looks like figure 19 in page 39 of http://www.jandy-downloads.com/pdfs/AquaPure_Manual.pdf and yes the temperature reading is accurate for both air and pool temp can you please guide me where can I find the Flow/Temp/Salinity Sensor http://www.jandy-downloads.com/pdfs/AquaPure_Manual.pdf Is the temperature reading accurate? yes for both pool water and air
  3. Hello All, my Jandy terminal display " general fault check aquapure " and also shows salt as 25500 PPM , it was 2200 PPM before I got this strange number. I had to go to pool equepment and unscrew two screws to access aquapure board where it shows colorine producing 70% then after a while it displays 172 then 185 then goes back to 70% . the cells seems pretty clean. thanks for any hints
×
×
  • Create New...